Pioneer PRO-610HD, PRO-510HD Coarse Adjustment of the Red, 2nd step, 4th step, 3rd step

PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5

In a case of an error in convergence:

	Adjustable points
Good adjustment:			Adjustment
5	20	2
			data

Bad adjustment:

-5	30	-3	Adjustment
			data

2nd step

Adjust so that the vertical lines become straight, taking care to preserve proper screen information volume and the linearity. Adjust the right half of the screen first, then the left half.

(See 3.4.)

4th step

Repeat 2nd and 3rd steps to take total balance. Then the adjust- ment for the green is completed.

To return from the fine adjustment mode to the coarse adjustment mode, press the MENU key once, then the DOT key.

Note: When the MENU key is pressed to quit MANUAL CONVERGENCE mode, the display will be unstable for several seconds. This is because the adjustment data are being written to the EEPROMs, and is not a malfunction. Do not perform any operation (power on/off, or pressing keys on the remote control unit or on the main unit, etc.) during this period, because doing so may affect your adjustment data.

Right half : Adjust from the edge toward the center.

Left half : Adjust from the center toward the edge.

3rd step

Adjust so that the horizontal lines become straight. Adjust the upper half of the screen first, then the lower half. (See 3.4.)

3.5 Coarse Adjustment of the Red

After the green adjustment is completed, quit MANUAL CONVERGENCE mode by pressing the MENU or MUTING key, then press the DOT key three times to enter OFFSET CONVER. MODE 3.

Select adjustment items for RH and RV, and roughly correct distortion to converge with the green. Adjustment is required for each screen mode

For adjustable items of the red and the blue, see the following table.

Numeric Key	RH	RV	BH	BV
0	STATIC	STATIC	STATIC	STATIC
1	SKEW	SKEW	SKEW	SKEW
4		KEY		KEY
6		PIN		PIN
7	LIN		LIN
8	SIZE	SIZE	SIZE	SIZE

Upper half : Adjust from the edge toward the center.

Lower half : Adjust from the center toward the edge.

210