Pioneer PRO-510HD Deflection Yoke Adjustment 2 -1 Deflection Yoke Lean Adjustment, Start

PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5

2Deflection Yoke Adjustment

2-1Deflection Yoke Lean Adjustment

Start	• Input a stable signal (e.g. from an LD player or SG) to
	the INPUT 1 connector.

•MENU → SETUP → Enter the MULTI-POINT (FULL) in the CONVERGENCE.

•The cross hatch disappears if there is no operation with the remote control unit for about 8 minutes. If the cross hatch disappears, repeat the above operation with the remote control unit.

Deflection

Yoke (L2)Deflection

CRT ASSY G Yoke (L1)

CRT ASSY B CRT ASSY R

Deflection

Yoke (L3)

Cross hatch

Deflection yoke

R.CRT DRIVE

B.CRT DRIVE G.CRT DRIVE Assy

AssyAssy

Turn to adjust.

Centering magnet

(Turn in either direction until cross signal becomes white.)

•Turn the deflection yoke of the replaced CRT so that the cross hatch of the color corresponding to the replaced CRT converges

with that of the CRTs not replaced.

Approx. 1cm

• When a CRT is replaced, check the position of the VM (Velocity Modulation) yoke.

2 -2Screen Center Adjustment

Start

Cross hatch

•Move the centering magnet of the deflection yoke for the replaced color so that the horizontal and vertical lines at the center of the screen align with the lines for a color not replaced.

•Secure the centering magnet from moving after adjustment is finished.

Deflection yoke

Centering magnet

(Turn in either direction until cross signal becomes white.)

201