Pioneer PRO-510HD, PRO-610HD Fine-adjustment of the Red, Rv Bv, 3.6.1, 3.6.3, 3.6.2, 3.6.4

PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5

• Pattern for each adjustment item

Key No. ` Key No. 1

STATIC	SKEW
RH
BH

Key No. 7

LIN

Key No. 8

SIZE

RV BV

Key No. `

STATIC

Key No. 8

SIZE

Key No. 1	Key No. 4	Key No. 6
SKEW	KEY	PIN

Note 1: When the red CRT is replaced, or when the deflection yoke for the red is replaced, prior to adjustment, tune the

= Fixed positioncenter of the image to the center of the screen by turning the centering magnet.

Note 2: When the CONVER. AMP Assy or DIGITAL CONV. Assy is replaced, make coarse adjustment as shown in 3.5 above.

3.6 Fine-adjustment of the Red

To fine-adjust the red, press the SET/ENTER key to enter MANUAL CONVERGENCE mode. Repeat the coarse adjustment described in "3.5 Coarse Adjustment of the Red" if necessary. Make adjustment for each SCREEN mode, and eliminate distortion to converge with the green.

3.6.1

Press the SET/ENTER key to enter MANUAL CONVERGENCE mode, and make adjustment in the same manner as with the green. First, adjust the vertical and horizontal the red lines at the center of the screen so that they converge with the green center lines.

3.6.3

Adjust the red horizontal lines so that they converge with the green horizontal lines. Proceed to adjustment of the upper half of the screen, then the lower half. Adjustment should be done from the part where convergence is greatly dislocated.

3.6.2

Adjust the red vertical lines so that they converge with the green vertical lines. Proceed to adjustment of the right half of the screen, then the left half. Adjustment should be done from the part where convergence is greatly dislocated.

3.6.4

Repeat the adjustments described in 3.6.2 and 3.6.3 so that all the red vertical and horizontal lines converge with the green lines. (Completion of one screen mode)

211