Pioneer PRO-510HD, PRO-610HD RETURN button, VOLUME buttons, INPUT 4 jacks, Initial mode

PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5

7RETURN button

Press to set the Projection Monitor to its initial mode.

Initial mode

Input selector:	Set to TV.
TV channel:	Remains at the last channel set.
VOLUME:	Remains at the last setting.
MUTING:	OFF
PICTURE
MODE:	STD
Parameters:	Set to 0.
3D Y/C LEVEL:	3
3D NR LEVEL:	3
COLOR TEMP:	STD
FLESH TONE:	ON
SOUND
MTS:	MAIN
Parameters:	Set to 0.
SURROUND:	OFF
SUPER BASS:	OFF
SCREEN
MODE:	NATURAL WIDE
V. POSITION:	Set to 0.
CC:	OFF
DPO:	OFF

∙When this button is pressed while adjusting the MULTI- POINT convergence, the MULTI-POINT convergence returns to the initial mode.

8VOLUME buttons

Press plus (+) button to increase the volume, press minus (–) button to decrease it.

CAUTION:

Do not press any operation button on the Projection Monitor or the remote control unit while recording. Signals from the MONITOR OUTPUT jacks may be temporarily interrupted when a button is pressed.

ATTENTION

The Projection Monitor Receiver will not function properly in the following cases.

∙An electrical discharge in the CRT.

∙Lightning storms.

∙High static electricity environment.

∙Poor voltage regulation in the power source.

If the Projection Monitor does not operate properly, reset it as follows:

1.Turn off the power of the unit with the 3 MAIN POWER switch.

2.After approximately 1 minute, turn on the power with 3 MAIN POWER switch and 4 POWER button.

If the normal operation cannot be restored after the above treatment, immediately unplug the power cord and call your nearest PIONEER-authorized service center.

NOTE:

On rare occasions, an electrical discharge may occur inside the CRT. It makes a short, sharp pop and either no sound is produced or the volume level changes by itself. The SPLIT screen and SEARCH screen functions will be cancelled automatically if an electrical discharge occurs when this function is engaged.

9INPUT 4 jacks

These inputs are for Video Movie and VCR. Use RCA-type pin plug cords (the same as those used in Hi-Fi systems) and S- VIDEO cords for connections. When the audio source to be connected is monaural, connect the source to the L-(MONO) jack.

271