Pioneer PRO-510HD 3Horizontal Size Adjustment, Reference, About H. Phase, Component 480P

PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5

5	-3Horizontal Size Adjustment			Note :
				Screen mode : FULL
	Start	1st FAC
		INPUT 1:Monoscope		Green screen
		ANT	1	H.SIZE

Note :

•After the V. SIZE adjustment, enter the H. SIZE adjustment by pressing "1" key.

•After the H. SIZE adjustment, check that V. SIZE is 91± 2%. If not, readjust the V. SIZE.

91% ± 2%

or

INPUT TV General broadcasting

VOL

Adjust the size so that the picture is completely displayed on the screen.

• Reference

The H PHASE adjustment is required if the left or right part of the screen becomes black, as illustrated below, depending on the format of the input signal (Ex. component 31.5 kHz, RGB 33K etc.).

Ex. Component 31K

Black

Animation

screen

Animation Animation

Move the part of animation leftward with CH+.

CH

• About H. PHASE

In principle, adjustment of the data for the H. PHASE is not required.

Check whether the H. PHASE data are the factory-preset values, as indicated below:

	Key No.	PRO-610HD	SD-582HD5
		PRO-510HD	SD-532HD5
				15K	: CONPOSITE, S COMPONENT (480i)
3	: H PHA (15K)	80	80
CH+ : H PHA (31K)		36	40	31K	: COMPONENT (480P)
				33K	: COMPONENT (1080i)
CH- : H PHA (33K)		-14	-8
9	: H PHA (31K RGB)	26	30
0	: H PHA (33K RGB)	-26	-20

The screen moves to the right or the left if the above data are in variance. (See the above figures.)

Note :

H PHASE is set in factory shipment by the most suitable value. But, there is the case that screen is missed as an upper figure occurs by the signal format of other apparatus to be connected to.

A screen can be improved as the following by the readjustment. However, attention is necessory because in convenience may occur when connected to another apparatus.

205