Recording
Note 3:
Be careful when using a keyboard to insert chapter marks, since if the Enter key is held depressed, multiple consecutive chapter marks may be inserted.
2Automatic Recording
7Recording Using IN/OUT Points Setting On the Function Menu’s APP section, use the [Auto Capture] = [IN/OUT Point] = [IN/OUT Point] command to set the time code for the IN and OUT points. When the Function Menu’s REC button is then pressed, the external VTR is automatically rewound to a position just preceding the selected IN point, and recording starts automatically from that point. When the designated OUT point is detected, the unit automatically enters the REC pause/stop mode.
APP section = [Auto Capture] = [IN/OUT Point]
=[IN/OUT Point]
The preroll time preceding the IN point can be changed from between 1 to 10 seconds before the point by using the Function Menu’s APP section =
[Auto Capture] = [IN/OUT Point] = [Preroll Time]
command. The time code delay compensation (offset) can be set to from 0 to
the APP section = [Auto Capture] = [IN/OUT Point] = [Offset (Frame)] command.
Note:
Frame accuracy during use of the auto recording function is as follows:
SET UP section = [Operation] | Offset (Frame) | |
= [Control Settings] | ||
value | ||
= [Time Code] | ||
| ||
± 1 Frame | ||
LTC | ± 1 Frame | |
IEEE1394 | ± 1 Frame | |
|
|
In order to match the phase with the input time code, the preroll should be set to about five seconds. The preroll value must be corrected using the source side component.
APP section = [Auto Capture] = [IN/OUT Point]
=[Preroll Time]
APP section = [Auto Capture] = [IN/OUT Point] =
[Offset (Frame)]
The APP section = [Auto Capture] = [IN/OUT Point] = [Record As] command allows designation of whether recording enters the REC pause mode, or stops completely when the OUT point is detected. When “Chapter (Pause)” is selected, the command also permits the insertion of a chapter mark at that point. When manual chapter mark insertion has been previously selected, optional chapter marks can be inserted by pressing the ENTER button during recording.
APP section = [Auto Capture] = [IN/OUT Point]
=[Record As]
English
39
