Pioneer PRV-LX10 manual Names of Parts, Front Panel Facilities 10 11 12 13 14 20 19 18

Names of Parts

Front Panel Facilities

1	2	3	4	5 6		7	8	9 10 11 12 13 14 15
28 27	26	25	24	23	22	21		20 19 18 17	16

No.	Name	Function
1	STANDBY/ON button	When the unit is in the standby condition, pressing this button causes the
		power to come on; the power indicator (to the left of the button) changes
		from orange to green. The main display section indicates system startup.
		After system startup is completed, the unit enters “idling condition,” and as
		the unit’s display changes to show the current time, the STOP button lights.
		When the unit is in the standby condition, if this button is pressed while
		holding the STOP button depressed, the Function Menu’s setting values
		will be reset to their factory defaults, and the power will then turn ON.
		If the button is held depressed for one second or more when the unit is in
		the idling condition, the unit will perform system shutdown, followed by
		return to the standby mode (the power indicator will change from green to
		orange). In the event operation becomes unstable and manual forced
		shutdown is required, hold the button depressed for four seconds or more.
2	Display sections
3	PLAY/REC indicator for DVD 1 drive	Lights to indicate operating state of DVD1 drive.
		Appears green during PLAY mode, and orange during REC mode.
4	DISC indicator for DVD 1 drive	Located to the right side of DVD1, this indicator light (orange) to indicate
		that a disc is loaded. (*1)
5	EJECT button (0) for DVD 1 drive	Press to open/close DVD1 disc tray. The DISC indicator flashes from the
		time the button is pressed until the disc tray closes fully.
6	DVD1, DVD2, HDD (Hard disk Drive)	These indicators light to show which drive has been selected with the
	indicators	DRIVE SELECT button (the indicator for the selected drive lights green).
7	PREVIEW button	When this button is pressed with the unit in the idling condition, a
		preview image/sound of the selected input (following encode and decode
		processing) is supplied to all output connectors except DV; when the
		button is pressed again, the unit returns to idling condition.
8	DRIVE SELECT button	Use to select the playback source and destination drive for recording. The
		selection changes in the order HDD (Hard disk Drive) = DVD1 = DVD2
		= DVD1&2. When a drive is selected, the corresponding indicator lights
		(green). When DVD1&2 is selected, DVD1 is designated as the playback
		source.
9	STOP button (7)	Functions to stop recording or playback. Until all internal operations are
		completed, the indicator flashes (white), and when fully completed, the unit
		returns to the idling condition and the indicator lights (white). Also, during
		idle condition, pressing the STOP button while holding down the CURSOR
		(bottom pointing arrow) button turns progressive encoding ON/OFF. (*2)
		To switch the selected TV system format (NTSC/PAL), hold the CURSOR
		(upward pointing arrow) button depressed and press the STOP button.

14

PRV-LX10 En