Pioneer VSX-24TX, VSX-27TX manual Bass Peak Level Manager, Select Exit and press Enter to return to

Surround Sound Set Up

Bass Peak Level Manager

The LFE (Low Frequency Effect) channel in Dolby Digital or DTS program sources can produce heavily concentrated ultra-low bass tones that may exceed the capabilities of your speaker system. The following steps show you how to set the peak level for the ultra-low bass (LFE) channel. If continuing from CROSSOVER NETWORK go to step 1. If starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p.24) first.

ë

S0URCERECEIVER

MULTI SYSTEM

OPERATION OFF

DVD/LD TV/SAT VCR1 VCR2

1 Select BASS PEAK LEVEL MANAGER (if continuing from CROSSOVER NETWORK it will already be selected).

See “Setting Up for Surround Sound“ on page 24 if you are unsure how to do this.

	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS

Press ENTER.

¦	7	3 8	Bass Peak Level Manager
- TUNING +		- STATION +
1 Á 4 ¢			[Setting Start ]
DTV ON/OFF DTV MENU		- CHANNEL +
1	2	3	[Setting Cancel]
4	5	6	[EXIT]
7	8	9
GUIDE		EXIT
	0	ENTER
+10		DISC

TV

TV VOL TV CONTROL VOLUME

TV FUNC

2 Output the test tone for the LFE channel and specify the peak level.

EFFECT	MENU MUTE		1	If your sub woofer has a volume control, set it to the middle
/CH SEL
	FUNCTION			position before proceeding.
	ENTER	1-3	2	Select SETTING START
	SIGNAL		3	Press ENTER.
	SELECT
	/dts

SYSTEM	THX	ADVANCED STANDARD
SETUP

REMOTE

SETUP MIDNIGHT DSP STEREO

Bass Peak Manager

DIGITAL NR

[Setting OK ]

Bass Peak Level

[ – 50]

DIGITAL MULTI PROCESSING AMPLIFIER

REMOTE CONTROL UNIT

MASTER VOLUME rotates to MIN (---dB). Then the test tone is output to the sub woofer or front or surround speakers.

4Use the 2 or 3 arrows to gradually increase the level of the LFE channel until the test tone begins to distort. Then go

back and leave the level setting at a point just before that. Press ENTER and the receiver will remember this bass output level.

To exit before outputting the TEST TONE

Select EXIT and press ENTER.

To exit while outputting the TEST TONE

Press ENTER.

3 Select EXIT and press ENTER to return to the

SYSTEM SETUP MENU.

This completes the speaker setup.

memo	If you select SETTING CANCEL no settings are input to the
	receiver but the screen remains on the TV. To escape the
	screen you must press EXIT.

32