Pioneer VSX-47TX manual Displays & Controls, Remote Control

Displays & Controls

Remote Control

This page describes the buttons on the remote control used to operate the receiver.

1 SETUP

2	S0URCE	TV	SYSTEM RECEIVER
			OFF
	DVD/LD	TV	SAT	TV CONT
3	MULTI CONTROL
	VCR1/	VCR2	VIDEO	MULTI
	DVR			OPERATION
	CD	CD-R/	TUNER	RECEIVER
		TAPE1
	DIMMER	INPUT ATT	LOUDNESS	SPEAKER A/B

1 2 3 4

4	VIDEO SEL	SIGNAL SEL	TAPE 2 EFFECT/CH SELL
	5	6	7	8
	TONE	BASS/TREBLE	– +10	+ DISC

90 ENTER

		DIRECT ACCESS DISP MODE
5	SYSTEM SETUP	REMOTE SETUP
	MENU
6	TUNER EDIT
		ENTER
7	STATUS	EXIT
	GUIDE	RETURN

	MPX	DTV ON/OFF
	¶	8	EXTRA MENU
8	TUNING –	BAND	TUNING +
	1	3	¡
	STATION –	DTV MENU CLASS	STATION +

	4		7	¢
	CHANNEL–			CHANNEL+
		TV INPUT	INPUT
9		TV CONTROL
	TV VOL	TV CH	MIDNIGHT	VOLUME
			DIGITAL
			NR
0	THX	STANDARD	STEREO	MUTE
			/DIRECT
	SURROUND		LISTENING
	ADVANCED	ADVANCED	MODE
	CINEMA	CONCERT

4Number buttons

These can be used for many purposes depend- ing on the mode of the remote control. When

!the in receiver mode the buttons operate as below:

@ Display DIMMER (see p.56)

Use to adjust the brightness of the receiver's

#display.

$INPUT ATT. button (see p.54)

Use to lower the input level of an analog signal that is too powerful, thus causing the receiver to distort. In this case the OVER (overload)

%indicator will be flashing furiously.

LOUDNESS button (see p.51)

^Switches the LOUDNESS mode on or off (for all modes except THX and MULTI CH IN).

SPEAKER A/B button (see p.71)

Use to select the speaker system. A is the

&primary setting. The button cycles through the

*	speaker systems as follows: A]B]A&B]off.
(	Different conditions apply when bi-amping the
	speakers. For this case refer to page 71.

)VIDEO SELECT button (see p.55)

PREPARATION

-		(DVD-A/SACD)			_
	ACOUSTIC	MULTI CH	LISTENING	LIGHT
	CAL	INPUT	CH SELECT

Î

=

~	AV PRE-PROGRAMMED AND LEARNING
	REMOTE CONTROL UNIT
	AXD7290

1Remote Control Display Screen

2SOURCE button

Use this button to turn off other components. You must input the preset code in order to use this function (see page 62-63).

Use to toggle between the different video input possibilities.

SIGNAL SELECT button (see p.45)

Press SIGNAL SELECT repeatedly to select one of the following:

ANALOG: To select an analog signal.

DIGITAL: To select a digital signal

2RF: To select a 2 RF signal

AUTO: This is the default. If there are analog, digital and 2 RF signals input, the receiver automatically selects the 2 RF signal. If there are analog and digital signals input, the digital will be selected.

TV button

This is a dedicated TV button. Use it to turn on/off your TV.

3MULTI CONTROL buttons

These buttons are the basic controls that switch the mode of the receiver and the remote control, which allows you to control your other components.

TV CONT: Press so that the remote control can operate the TV control commands.

27