Pioneer VSX-47TX manual During playback of a DVD, Audio source, the player, Shows a transfer rate

	Techno Tidbits & Problem-solving
Symptom	Cause	Remedy
During playback of a DVD	• The multi channel connections are	• This is not a malfunction. See the
audio source, the player	analog, so there is no digital transfer.	player's manual for more details.
shows a transfer rate of
96kHz, but the receiver does
not.
During playback of a DTS	• The receiver may be on a different mode	• Switch to STANDARD mode (see p.43).
96/24 source, the display	than STANDARD.
doesn't show 96kHz	• One of the DIGITAL NR, MIDNIGHT,	• Turn it/them off (see p.50-52).
	LOUDNESS, and TONE features are
	switched on.
	• The setting for speakers other than the	• The source has been downmixed to 48
	surround back is set to NO.	kHz.
	• Re-EQ is set on.	• Set Re-EQ off (see p.98).
During playback of a 96kHz	• The receiver may be on a different mode	• Switch to STEREO mode (see p.43).
source, the display doesn't	than STEREO.
show 96kHz	• One of the DIGITAL NR, MIDNIGHT,	• Turn it/them off (see p.50-52).
	LOUDNESS, and TONE features are
	switched on.
	• Re-EQ is set on.	• Set Re-EQ off (see p.98).

Remote control
Cannot be remote	•	The remote control batteries have worn
controlled.	out.
	•	Too far away or bad angle of operation.
	•	There is an obstacle between the
	receiver and the remote control.
	•	Strong light such as fluorescent light is
	shining onto the unit's remote control signal
	light-receiving window.
	•	A cord is connected to the CONTROL IN
	terminal on this unit.
	•	The IR -Receiver type is mismatched
	with the setting.

•Replace the batteries (see p.7).

•Operate within 7 m, 30° of the remote sensor on the front panel (see p.8).

•Remove the obstacle or operate from another position (see p.8).

•Avoid exposing the remote sensor on the front panel to direct light.

•Connect cord to the correct jack.

•Disconnect the IR Receiver from the rear panel, and set to the other IR Receiver type using the remote control.

Other components can't be	• The preset code settings are wrong.	• Input the correct preset code.
operated with the system	• The battery wore out and the system	• Reset the proper system settings.
remote.	settings were cleared.
The SR cable is connected,	• The SR cable hasn't been connected	• Reinsert the SR cable, making sure it is
but the connected	properly.	the right jack (see p.78).
components can't be	• The rest of the component connection	• Make sure an analog connection has
operated with the remote.	have not been made.	been made between the units.
	• The component you have hooked up is	• This is not a malfunction.
	not SR compatible.
Miscellaneous
HOME THX 7.1 channel	• The current setting is for only one	• Connect two surround back speakers and
mode is selected, but there	surround back speaker.	make the settings accordingly (see p.25,
are certain options that can't		36-37).
be chosen.
There seems to be a time lag	• The subwoofer channel can be delayed	• The MCACC system will automatically
between the speakers and	slightly if run through a low-pass filter.	compensate for a delay in the subwoofer
the output of the subwoofer.		output during the Auto Surround Sound
		Setup.

EXPERT

109