Pioneer VSX-47TX manual 9Some auto setup instructions will be, listed, make sure to follow them

Quick Start Guide Part2

10	1. Auto Surround	Setup
	Connect microphone
	Please be quiet
	Move obstacles	away
	If you have a subwoofer
	turn power on	and
	turn volume	up

[Start] [Cancel]

\ 1. Auto Surround Setup

Please Wait

Caution!!

Test tone is output loudly.

[Cancel]

\
Auto Surround Setup
	Now Analyzing•••
Environment Check
Ambient Noise			[OK]
Microphone			[OK]
Speaker Level			[OK]
[		]
	Cancel

11								\
	1. Auto Surround Setup
				Front						[ YES ]
				Center						[ YES ]
				Surround						[ YES ]
				SurrBack						[ NO	]
				Subwoofer						[ NO	]
	[		OK		]
		[Retry]
	[ERR Fix								SP.]
	[Return							to Menu]
	Auto Surround Setup
				Now Analyzing•••
	Surround
								Analysis
	Speaker							Systems			[OK]
	Channel							Delay			[OK]
	Channel							Level			[OK]
	Acoustic								Cal	EQ	[OK]
	[						]
			Cancel
	Speaker							Systems Check
	”			Normal					Surround		”
	Front									[SMALL]
	Center									[SMALL]
	Surround									[SMALL]
	SurrBack									[SMALLX2]
	Subwoofer									[ YES	]
	[		Next			]		(	Back/Next		)
	[Return]

9Some auto setup instructions will be

listed, make sure to follow them.

Make sure you have: hooked up the remote control microphone and moved obstacles to the speakers out of the way. If you have a subwoofer make sure it is turned on and has the volume turned up.

WARNING: The test tones are very loud!! Make sure there are no infants or small children in the room and that no one who will be scared, upset or injured by loud noise is present. You yourself may want to wear ear- plugs. It is possible to lower the volume of test tones, but this could result in incorrect speaker settings.

10 If you have followed all setup instructions and warnings above make sure that the arrow is pointed to START and press ENTER. Put the remote control into the its stand and be prepared for loud test tones.

Try to be as quiet as possible after hitting ENTER. The test tones may take up to 30 seconds.

The volume automatically increases to 0dB, then the system will output some test tones and establish ambient noise levels, the microphone status, and what speakers you hooked up.

11 Check the speaker settings on the OSD

If they match your speaker configuration make sure OK,GO NEXT is selected and press ENTER. Put the remote control into the its stand again. The test tones will be output loudly again. The test tones may take up to 5 minutes this time.

After it has finished, you see the SPEAKER SYSTEMS CHECK screen. If you want to view the settings select NEXT and press ENTER repeatedly. If not, simply go to step 13.

If they do not match the speaker configuration you hooked up and you wan to try again select RETRY with 5∞ buttons and press ENTER. Put the remote control into the its stand again. Follow the instructions above from step 10.

If the speaker settings do not match the speaker configuration you connected and you want to input the settings manually select ERR=FIX SP with the 5∞ buttons, press ENTER. Put the remote control into the its stand again. and go to step 12.

If you see an ERR message in the right side column, there may be a problem with the speaker connection. If selecting RETRY doesn't fix the problem, turn off the power and check the speaker connections.

	12 Use the ∞5 buttons to select a speaker
14	then the 2 3 buttons to select the size
	of each speaker individually.