Pioneer VSX-47TX Assigning the Component Video Inputs, Use the 5∞ buttons to select, reassign

Advanced Setup

Assigning the Component Video Inputs

This receiver has three component video inputs. By default they act as video inputs for the DVD/LD, TV and SAT functions, but you can reassign them if you want to use them as video inputs for other receiver functions. For example, if you have a DVD recorder connected to the VCR1/DVR jacks and want to use its component video output, and you're not using the COMPONENT VIDEO IN 3 jacks on this receiver, you can reassign the input from SAT to VCR1.

See pages 16–19 for more on connecting equipment using component video cords.

SETUP

S0URCE	TV	SYSTEM RECEIVER
		OFF
DVD/LD	TV	SAT	TV CONT
MULTI CONTROL
VCR1/	VCR2	VIDEO	MULTI
DVR			OPERATION

1Turn on the receiver and your TV, press RECEIVER on the remote control.

2Press the SYSTEM SETUP button.

	DIMMER	INPUT ATT	LOUDNESS SPEAKER A/B		1	3	Looking at the on-screen display on
	CD	CD-R/	TUNER	RECEIVER
		TAPE1
	1	2	3	4			your TV, use the 5∞ buttons to
	VIDEO SEL	SIGNAL SEL	TAPE 2	EFFECT/CH SELL
	5	6	7	8			select INPUT ASSIGN. Press the
	9	0		ENTER
	TONE	BASS/TREBLE	– +10 + DISC
2	MENU		DIRECT ACCESS DISP MODE				ENTER button.
	SYSTEM SETUP			REMOTE SETUP	3-8
	TUNER EDIT
	STATUS	ENTER		EXIT

GUIDE		RETURN	4 Use the 5∞ buttons to select
MPX	DTV ON/OFF
¶	8	EXTRA MENU	C'NENT VIDEO IN then press ENTER.
TUNING –	BAND	TUNING +

3

4

System Setup

[ Auto Surround Setup ]

[1. Input Assign ]

[2. Surround Setup]

[3. Expert Setup]

[4. THX Audio Setup]

[Exit]

1.Input Assign

[ 1.Digital-In Select ] [ 2.C'nent VideoIn]

5Use the 5∞ buttons to select the component video input you want to

reassign.

In the example above, we would select C'NENT-IN 3.

6 Use the 2 3 buttons to assign a receiver function.

Choose between DVD/LD, TV, SAT, VCR1 and VCR2. In the example above, we would select VCR1

[Return]

5	1.2. C' nent Video In
	C' nent-In1				]
			DVD/LD[
	C' nent-In2		[	TV	]
	C' nent-In3	[		SAT	]
	[Return]
6	1.2. C' nent Video			In
	C' nent-In1	[ DVD/LD ]
	C' nent-In2	[		TV	]
	C' nent-In3	[ VCR1			]

[Return]

7When you're finished use the 5∞ buttons to select RETURN and press

ENTER.

You will leave the "Assigning the Component Video Inputs" mode.

8Use the 5∞ buttons to select

RETURN and press ENTER, again. Then, use the 5∞ buttons to select

EXIT and press ENTER.

memo	If you connect any source component to the
	receiver using a component video input, you
	should also have your TV connected to this
	receiver's component video output.

EXPERT

89