Pioneer VSX-47TX Advanced Setup, Turn on the receiver and your TV, Your TV, use the 5∞ buttons to

Advanced Setup

Assigning the Digital Inputs

If you did not hook up your digital equipment in accordance with the default settings for the digital inputs (see p.17, 19 & 22-23) you need to complete the procedure below. You have to do this in order to tell the receiver what digital equipment is hooked up to which terminal so the buttons on the remote correspond to what you have hooked up.

1Turn on the receiver and your TV,

MULTI CONTROL			TV CONT		press the RECEIVER on the remote
DVD/LD	TV	SAT
VCR1/	VCR2	VIDEO	MULTI	1	control.
DVR			OPERATION
CD	TAPE1	TUNER	RECEIVER
	CD-R/
DIMMER	INPUT ATT LOUDNESS SPEAKER A/B

2

1	2	3		4	2 Press the SYSTEM SETUP button.
5	6	7		8
VIDEO SEL SIGNAL SEL		TAPE 2	EFFECT/CH SELL
TONE BASS/TREBLE		– +10		+ DISC

90 ENTER

	DIRECT ACCESS DISP MODE			3	Looking at the on-screen display on
SYSTEM SETUP		REMOTE SETUP	3~8
TUNER EDIT
MENU
GUIDE	ENTER	RETURN			your TV, use the 5∞ buttons to
STATUS		EXIT			select INPUT ASSIGN. Press the
MPX	DTV ON/OFF
¶	8	EXTRA MENU
TUNING –	BAND	TUNING +			ENTER button.
STAT ON –	DTV MENU CLASS	STAT ON +
1	3	¡

3

4

6

System Setup

[ Auto Surround Setup ]

[1. Input Assign ]

[2. Surround Setup]

[3. Expert Setup]

[4. THX Audio Setup]

[Exit]

1.Input Assign

[ 1.Digital-In Select ] [ 2.C' nent Vudeo In ]

[Return]

1.1. Digital-In	Select
Digital-1	[ DVD/LD ]
Digital-2	[	CD	]
Digital-3	[	SAT	]
Digital-4	[	VCR1	]
Digital-5	[	CD-R	]
RF IN	[ DVD/LD ]

4DIGITAL-IN SELECT should be selected, if not use the 5∞ buttons to select it. Press the ENTER button.

5Use the 5∞ buttons to move through the different digital input settings and use the 2 3 buttons to select the component that you hooked up to that digital in.

6If you're not sure which component is connected to which digital in, look on the back of the receiver and check the cables you connected.

7When you're finished use the 5∞ buttons to select RETURN and press

ENTER.

This exits the "Assigning the Digital Inputs" mode.

[Return]

memo

•The possible digital inputs that can be assigned are: DVD/LD, TV, SAT, VCR 1/DVR, VCR 2, CD, CD-R/TAPE 1 (except for a 2 RF input which doesn't include CD, CD-R/TAPE 1).

•If you assign a digital input to a certain function (for example DVD/LD) then any digital inputs pre- viously assigned to that function will automati- cally be set to OFF. This is because one func- tion cannot be assigned to two different places (except for RF IN).

8Use the 5∞ buttons to select

RETURN and press ENTER, again. Then, use the 5∞ buttons to select

EXIT and press ENTER.

88