Pioneer VSX-47TX manual Setting Start The Master Volume is set to, Setting in step, Go on to step

Advanced Setup

BASS PEAK LEVEL

The LFE (Low Frequency Effect) channel in Dolby Digital, DTS program sources can produce heavily concentrated ultra-low bass tones that may exceed the capabilities of your speaker system. The following steps show you how to set the peak level for the LFE channel. If continuing from the preceding page the BASS PEAK LEVEL MANAGER should be selected.

SETUP

S0URCE	TV	SYSTEM RECEIVER
		OFF
DVD/LD	TV	SAT	TV CONT
MULTI CONTROL
VCR1/	VCR2	VIDEO	MULTI
DVR			OPERATION
CD	CD-R/	TUNER	RECEIVER
	TAPE1
DIMMER	INPUT ATT	LOUDNESS	SPEAKER A/B
1	2	3	4
VIDEO SEL	SIGNAL SEL	TAPE 2	EFFECT/CH SELL

Follow steps 1-3 on page 90, if necessary, to get to the starting point mentioned here.

1BASS PEAK LEVEL should be selected if, it isn’t use the 5∞ buttons to select it. Press ENTER.

2Use the 5∞ buttons to select

SETTING START or SETTING CANCEL.

5	6	7	8		SETTING START: The MASTER VOLUME is set to
TONE	BASS/TREBLE	– +10 + DISC
9	0		ENTER		MIN (----dB), a test tone plays back and you make the
SYSTEM SETUP			REMOTE SETUP
	DIRECT ACCESS DISP MODE				setting (in step 3).
TUNER EDIT				1~6
MENU					SETTING CANCEL: This setting won't limit the peak
STATUS	ENTER		EXIT
GUIDE			RETURN		level of the LFE channel.
MPX	DTV ON/OFF		TUNING +
TUNING –	BAND				For SETTING START, select it and press ENTER. Then
¶	8		EXTRA MENU		go on to step 3.
1	3		¡
STATION –	DTV MENU CLASS		STATION +		For SETTING CANCEL, select it and press ENTER.
4	7		¢
CHANNEL–			CHANNEL+		The bass peak level setting is finished. Go on to the

next setup.

1

2

4.Expert Setup

[1. OSD Adjustment ]

[2. Bass Peak Level]

[3. D-Range Control]

[4. Multi-Ch In Select]

[5. Function Rename]

[6. Multi-Room Setting]

[Return]

4.2.Bass Peak Level Manager

[Setting Start] [Setting Cancel]

[Return]

Please Wait

3Use the 2 3 buttons to adjust the test tones and specify the bass peak

level.

1Raise the level gradually.

2Set the bass peak level at the point just before the tone starts to distort.

Be careful! Test tones play back at loud volumes . Make sure there are no infants or small children in the room at distortion level.

If the YES or PLUS setting on the subwoofer is selected the test tone will only play back from the subwoofer. If not, the test tone will play back from all speakers set to LARGE except for the subwoofer.

3	4.2. Bass		Peak		Level
					Manager
	[			]
		Setting	OK		Level
		Bass Peak
					[	–80	]
	[Setting		Cancel]

memo	• If you set the THX Ultra2 feature to
	YES on p.96 the BASS PEAK LEVEL
	feature will be cancelled.

4Press ENTER.

The display on the receiver will show RESUME and the MASTER VOLUME will return to its original position.

5If you want to continue EXPERT SETUP use the 5∞ buttons to select

the next setup and press ENTER.

Go on to the next page.

6If you want to finish EXPERT SETUP use the 5∞ buttons to select

RETURN and press ENTER. Then use the 5∞ buttons to select EXIT and press ENTER.

92