Polycom 1725-16823-001 manual Deploying Phones From the Provisioning Server

Setting Up the Polycom VVX 1500 D Phone

Deploying Phones From the Provisioning Server

Warning	As of UC software 3.3.0, you only need to configure the parameters that do not
	match their “built-in” defaults.
	Certain configuration settings in Polycom UC Software 3.3.0 release are not
	backward compatible to the previous configuration files (sip.cfg and phone1.cfg).
	Review all configuration files used to configure the VVX 1500 D phones for previous
	software releases.
	For more information, refer to Configuration Files on page A-1.
	You can create two configuration files for each phone and one configuration
	file for all phones in your installation or you can put all configuration
	parameters into one file. The example below shows one configuration file.
	For more information on why to create another configuration file, refer to the
	“Configuration File Management on Polycom VVX 1500 D Phones” white
	paper at
	http://www.polycom.com/global/documents/support/technical/products
	/voice/white_paper_configuration_file_management_on_soundpoint_ip_ph
	ones.pdf .
Note
	Use an XML editor to create/edit the configuration files. In this way, all configuration
	files that you create will be valid XML files.
	If the configuration files are not valid, they will not load on the phone. An error
	message will be logged to the provisioning server.
	For more detailed information on specific parameters in configuration files,
	refer to Configuration Files on page A-1.
	Deploy Polycom VVX 1500 D phones by:
	1. Creating a Phone Configuration File
	2. Creating a Master Configuration File
	3. Downloading the New Configuration

Creating a Phone Configuration File

	To create a phone configuration file:
Note
	Obtain the phone’s MAC address from the barcoded label on underside of phone or
	on the outside of the shipping box.
	1. Create a phone configuration file.
	For example, create phone_0004f2be80a6.cfg

2 - 13