SpectraLink Corporation

Configuration and Administration—NetLink e340/i640 Wireless Telephone

 

 

 

Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

 

 

 

 

 

 

 

 

Admin Menu Items

2nd Level

3rd Level

4th Level

5th Level

 

 

 

 

 

 

 

 

 

Transmit Power

*Maximum

 

 

 

 

 

 

50 mW †

 

 

 

 

 

 

30 mW †

 

 

 

 

 

 

20 mW

 

 

 

 

 

 

15 mW

 

 

 

 

 

 

10 mW

 

 

 

 

 

 

5 mW

 

 

 

 

Diagnostics

Run Site Survey

 

 

 

 

 

 

Diagnostics Mode

Diagnostics On

 

 

 

 

 

 

*Diagnostics Off

 

 

 

 

 

Syslog Mode

*Disabled

 

 

 

 

 

 

Errors

 

 

 

 

 

 

Events

 

 

 

 

 

 

Full

 

 

 

Restore Defaults

* default setting

† 50 mW and 30 mW only appear if Regulatory Domain is set to None or 01.

Phone Config

License Option

License Option lets you select the VoIP protocol that your site is licensed to download and run. The MiNET protocol to use for the NetLink e340/h340 and i640 Wireless Telephones requires License Option 014. Any other protocol will cause the handset to malfunction.

Clear PIN Number

The PIN number is saved in the handset’s local memory. If it is necessary to change the PIN number assigned to this handset, clear the existing number through this Admin menu option and power cycle the handset. The PBX will request a PIN number when the handset is powered on, just as it does with the 5220 IP Phone. Enter the PIN number and press the Send softkey. The new PIN number will be sent to the PBX. If the new PIN is accepted by the PBX, it will tell the handset to save the PIN in its local memory.

5220 Emulation

Disable 5220 is the default and should be used if configuring for the SX-200 ICP or the 3300 ICP is using software version 5.1 or greater. With this revision, the Mitel Networks system became capable of recognizing NetLink Wireless Telephones. If the 3300 ICP software version in use is below 5.1, select Enable 5220 to allow Mitel Networks to recognize the NetLink Wireless Telephone as a 5220 IP Phone.

OAI On/Off

SpectraLink’s Open Application Interface (OAI) enables third-party computer applications to display alphanumeric messages on the handset display and take input from the handset keypad. Refer to the Open Application Interface (OAI) Specification documentation for information about administering the OAI Gateway and the services it can provide.

If you have an OAI Gateway installed in your system, OAI may be optionally enabled in each handset. You may select whether the handset should attempt to connect to the SpectraLink OAI Gateway by choosing either the Enable or Disable options in this menu.

PN: 72-1084-02-G.doc

Page 20

Page 20
Image 20
Polycom Mitel Networks 3300, 72-1084-02, SX-200 ICP manual Admin Menu Items 2nd Level 3rd Level