Polycom SX-200 ICP, 72-1084-02, Mitel Networks 3300 manual Pbx

SpectraLink Corporation	Configuration and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
Message	Description	Action
Erasing Memory	Handset has determined that a download	None. When the progress bar fills the
	should occur and is erasing the current	display line the erase operation is
	software from memory.	complete.
		Do not turn the handset off during this
		operation.
Far End TCP Close	The handset has lost communication with the	No action necessary. After about 20
	PBX.	seconds, the handset will re-initialize and
		reconnect to either the same PBX or to
		another PBX if it has been instructed to do
		so or the first PBX fails to respond.
Files Too Big	Handset software download files are	Download new software from the
	incorrect or corrupted	SpectraLink site per Software
		Maintenance.
Flash Config Error	Handset internal configuration is corrupt.	Perform "Restore Defaults" operation via
		administrator menus [or reprogram with
		Configuration Cradle]
Forced Redirect	The PBX has told the handset to re-register	No action necessary.
	with another PBX.
Get Button Defs	The Handset is attempting to get definitions	No action necessary.
	from the PBX of how the user-programmable
	keys are currently programmed.
Initializing …	The handset is performing power on	None. This is informational only.
	initialization
Internal Err. # #	The handset has detected a fault from which	Record the error code so it can be
	it cannot recover.	reported.
		Turn the handset off then on again.
		If error persists, try registering a different
		handset to this telephone port.
		If error still persists, contact SpectraLink
		Technical Support and report the error.
Invalid Redirect	The PBX has told the handset to re-attempt	No action necessary.
	registration with another PBX. The reason
	code in the redirect message is invalid.
Multiple GW Res	More than one NetLink SVP Server has	Caused by two or more handsets sharing
	responded	the same IP address. Assign unique IP
		addresses to each phone.
Multiple SVP Reg	y…y = SVP IP address	This can happen if the handset has been
yyy.yyy.yyy.yyy	Handset received responses from multiple	re-configured to use a different SVP server
	SVP Servers; displays IP address of one	and then powered-up before the previous
	responding SVP Server	server has had time to determine that the
		handset is no longer connected to it. The
		problem should go away after about 30
		seconds.
Must Upgrade SW!	Handset software is incompatible with	Download new software from the
	hardware.	SpectraLink site per Software
		Maintenance.

PN: 72-1084-02-G.doc Page 55