Polycom SX-200 ICP manual NetLink Wireless Telephone Status Messages, Message Description Action

SpectraLink Corporation	Configuration and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

12.3 NetLink Wireless Telephone Status Messages

NetLink Wireless Telephone status messages provide information about the NetLink e340/h340/i640 Wireless Telephone's communication with the AP and host telephone system. The following table summarizes the status messages, in alphabetical order.

Message	Description	Action
3 chirps	Handset is not able to communicate with the	None. This is only a warning, the call will
	best AP, probably because that AP has no	handoff to the best AP once it becomes
	bandwidth available.	available.
Address Mismatch	Handset software download files are	Download new software from the
	incorrect or corrupted	SpectraLink site per Software
		Maintenance.
ASSERT xxx c	The handset has detected a fault from which	Record the error code so it can be
Line yyy	it cannot recover.	reported.
		Turn the handset off then on again.
		If error persists, try registering a different
		handset to this telephone port.
		If error still persists, contact SpectraLink
		Technical Support and report the error.
Assoc Failed	x…x = AP MAC address.	Check handset and AP security settings.
xxxxxxxxxxxx	Handset association was refused by AP;	Ensure AP is configured per Configuration
	displays MAC of failing AP.	Note.
		Try another AP.
Assoc Timeout	x…x = AP MAC address.	Check handset and AP security settings.
xxxxxxxxxxxx	Handset did not receive association	Ensure AP is configured per Configuration
	response from AP; displays MAC of failing AP	Note.
		Try another AP.
Auth Failed	x…x = AP MAC address.	Check handset and AP security settings.
xxxxxxxxxxxx	Handset authentication was refused by AP;	Ensure AP is configured per Configuration
	displays MAC of failing AP	Note.
		Try another AP.
Auth Timeout	x…x = AP MAC address	Check handset and AP security settings.
xxxxxxxxxxxx	Handset did not receive authentication	Ensure AP is configured per Configuration
	response from AP; displays MAC of failing AP	Note.
		Try another AP.
Bad Code Type xx	xx, yy = software license types	Download new software from the
Expected Code Type yy	Handset software does not match current	SpectraLink site per Software
	handset license selection	Maintenance.
Bad Config	Some needed configuration parameter has	Check all required handset configuration
	not been set	parameters for valid settings
Bad ESSID	The handset is configured for “static ESSID”	Enter an ESSID in the configuration
	(as opposed to “Learn once” or “Learn	settings or change to one of the “Learn”
	always” and no ESS ID has been entered.	modes.
Bad Phintl File	Handset software download files are	Download new software from the
	incorrect or corrupted	SpectraLink site per Software
		Maintenance.

PN: 72-1084-02-G.doc Page 52