Polycom SX-200 ICP, 72-1084-02, Mitel Networks 3300 manual Message Description Action

SpectraLink Corporation	Configuration and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
Message	Description	Action
Select License	The correct protocol has not been selected	Using the administrative menus, select one
	from the license set.	license from the set to allow the phone to
		download the appropriate software.
Server Busy	Handset is attempting to download from a	None, the handset will automatically retry
	TFTP server that is busy downloading other	the download every few seconds.
	devices and refusing additional downloads.
Skt Open Fail	Socket open fail. Occurs when the Handset	If the PBX is inoperative and resiliency is
	tries to connect to the PBX but there is no	not active or the handset cannot locate a
	response. If resiliency is active, the handset	backup PBX, turn off the handset and
	will keep trying.	repair the primary PBX. Note that it may be
		advisable to reconfigure the backup PBX to
		be the primary PBX if the repair is more
		time-consum-ing than the reconfiguration.
Storing Config	Handset is storing changes to handset	None. Informational only. The handset may
	configuration.	display this briefly following a
		configuration change or software
		download.
SVP Service Rej.	The NetLink SVP Server has rejected a	The handset will restart and attempt to re-
	request from the handset	register with the SVP Server, which should
		fix the problem. Report to your
		administrator if it keeps happening.
System Busy	y…y = SVP Server IP Address	All call paths are in use, try the call again
yyy.yyy.yyy.yyy	SVP Server has reached call capacity.	in a few minutes.
System Locked	NetLink SVP Server is locked	Try call again later, system has been
(with Busy Tone)		locked for maintenance
	System Gateway is locked	Try the call again, system has been locked
		for maintenance
TCP Rcv Timeout	If the PBX has failed, this message may	Wait for the handset to cycle through
	display briefly as the handset tries to connect	attempts to connect to the backup PBX.
	to the backup PBX in a resilient setting. This	See SKT Open Fail above.
	message may be replaced by the SKT Open
	Fail message if the handset is unsuccessful
	at connecting with the backup PBX or if
	resiliency is not programmed.

PN: 72-1084-02-G.doc Page 58