Polycom Mitel Networks 3300 manual Startup Sequence, Icon Icons shown in bold turns off when, Ext

SpectraLink Corporation	Configuration and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

3.3Startup Sequence

The handset goes through an initialization sequence at startup. The line icons 1-9 display and count down as the handset steps through this sequence. This is usually very rapid. If there is any difficulty at any step that prevents initialization from continuing, an error message will display and the related icon(s) will stay on. Please see the error table at the back of this document for instructions on how to handle error messages that occur during initialization.

Icon	The icon(s) shown in bold turns off when:
123456789	The handset has located and authenticated and associated with at least one AP, and is
	proceeding to bring up higher-layer networking functions.
12345678	The handset is either configured for Static IP, or if configured for DHCP the DHCP discovery
	process has started.
1234567	If DHCP is configured, a DHCP response was received which contains a good DNS server
	configuration.
123456	Note: Only valid on non-SRP protocol. Indicates one of the following:
	Static IP configuration, or
	SVP Server address found in DHCP response, or
	SVP Server address found via DNS lookup.
12345	All networking functions are complete (notably, DHCP) and the handset is proceeding with
	establishing the SRP link to the SVP Server.
1234	The SRP link is established, all network stack initialization is complete, proceeding with
	application-specific initialization.
123	The link between the handset and the PBX is established.
12	The handset has registered to the PBX.
12	Requested if PIN had not previously been entered, if PIN has been cleared, or if MAC address
Please Enter PIN	not entered in the DN con-figuration table on the PBX.
	The PIN may be up to 18 characters. The first few are a secret number defined at the PBX, the
	rest are the extension of this handset. User must enter a valid PIN number and press the Send
	softkey. Alternately, the handset may be configured in the DN configuration table on the PBX.
	Note: there is no timeout and the user must reboot if an invalid PIN is entered.
1	The handset has received a definition string for each of the 14 programmable buttons. If the
	handset hangs up at this point, there has been an undetected error in the retrieval process
	and the handset will need to be rebooted.
(no icons)
	Initialization is complete. The handset is in standby mode ready to receive and place calls.
EXT. XXXXX

PN: 72-1084-02-G.doc Page 14