Polycom DOC2560B manual Procedure 2 Product Registration, Obtaining the Activation Key, 2-20

Chapter 2-First Time Installation and Configuration

2Power the RMX On.

AC System - Turn ON the power by pressing on the power switch located on the rear panel of the RMX 1500/2000/4000.

DC System (RMX 4000) - Turn ON the Main that supplies power to the RMX and then turn ON each of the DC power rail modules.

The parameters in the lan.cfg file are uploaded from the USB key to the RMX’s memory and applied during the power-up sequence. System power-up sequence may take up to five minutes.

During the First-time Power-up the red ERR LED on the RMX’s front panel remains ON until both the Management and IP Network Services have been defined.

When the RMX's configuration is completed (including the Management and IP Network Services), and if there are no System Errors, the green RDY LED on the CNTL module (on the RMX’s front panel) turns ON.

3Remove the USB key.

Procedure 2: Product Registration

Before the RMX can be used, it is necessary to register the product and obtain an Activation Key.

During first-time power-up, the Product Activation dialog box is displayed, requesting you to enter an Activation Key.

Obtaining the Activation Key

1Access the Service & Support page of the Polycom website at: http://support.polycom.com

2Login with your Email Address and Password or register as a new user.

3Select Product Registration.

4Follow the on-screen instructions for Product Registration and Product Activation. (The RMX’s serial number is on a sticker on the back of the unit, if needed.)

5When the Product Activation Key is displayed, write it down or copy it for later pasting into the Activation Key field of the Product Activation dialog box.

2-20