THROUGH-DOVETAILS with Unlimited Board Width | Porter-Cable 4210

Fig. 8A

Fig. 8C

FITTING THE JOINT

Step 1 - Orient the template so that the “PINS” side is facing you (Fig. 9A).

Step 2 - Loosen the two #10 screws.

Step 3 - If the joint is too loose, move the template toward you slightly.

Step 4 - If the joint is too tight, move the template away from you slightly.

Step 5- Tighten the screws loosened in STEP 2. Step 6 - Cut the pin board again and check for fit.

Fig. 8B

Fig. 8D

Fig. 9A

THROUGH-DOVETAILS WITH UNLIMITED BOARD WIDTH

You can cut dovetails in boards wider than the templates mounted on clamping boards by cutting the first part of the joint, sliding the templet down the workpiece, and cutting the rest of the joint.

NOTE: Become familiar with the procedure for cutting through-dovetails with a template on a clamping board before attempting working with unlimited board width.

SETUP

Remove the half-blind depth bracket. Other than that, the setup is identical to the previous setup.

8

Image 8

Porter-Cable 4210, 4212 instruction manual THROUGH-DOVETAILS with Unlimited Board Width, Fitting the Joint

Contents

Supplementary Instructiondovetail JIG Manual Table of Contents Safety Guidelines Definitions Important Safety Instructions Background Information Additional Safety RulesReplacement Parts Operation Miscellaneous Techniques THROUGH-DOVETAILS with Clamping Boards SetupTemplates Mounted to Clamping Boards Cutting the Pins Cutting the Tails THROUGH-DOVETAILS with Unlimited Board Width Fitting the Joint Set the router bit depth, using the pencil mark from Step Fitting the joint is identical to the previous section a HALF-BLIND Dovetails with Clamping Boards Blind Dovetails with Tail Boards Thicker than 7/8 Cutting the Joint Wood Grain Using a Router Table THROUGH-DOVETAIL BIT Combinations Readily Available Alternate Router BitsTHROUGH-DOVETAIL Bits HALF-BLIND Dovetail BIT Readily Available Dovetail Dado Bits BOX Joint BitsBOX Joint Bits Readily Available HALF-BLIND Dovetails with Tail Boards Thicker than 7/8 Mitering the Pins Mitered THROUGH-DOVETAIL THROUGH-DOVETAIL, SKIPPED-PIN Method Mitering the Tails HALF-BLIND DOVETAIL, Skipped PIN Method Cutting the Pins SAW Kerf Allowance Method Cutting the Tails Multiple Spacer Method END-TO-END JointsFitting and Cutting the Joint BOX END-TO-END Joints Drawers with Dovetail Dados Dovetail END-TO-END Joints Wooden Hinges Hinges with a Drilled Hole Hinges with ROUTER-MADE Grooves Hinges with ROUTER-MADE Grooves Obtuse Angled Joints Setup with the Template Mounted to the Base of the JIGAngled Joints Setup with the Template Mounted to a Clamping Board Cutting the Tails Cutting the Pins Acute Angled Joints SLANTED-SIDE Joints COMPOUND-ANGLE Joints Setup Blade Tilt Angle Make Angled CUT Make the First Joint Inlayed JointsInlayed Through Dovetail Make the Second Joint Inlayed HALF-BLIND DovetailCUT OFF the Inlay Board 100 13/128 050 042 028 014 Inlayed BOX Joint Tables of Commonly Available Router BIT Sizes Through Dovetail Router BIT CombinationsHALF-BLIND Dovetail Bits BOX Joint BIT Combinations Accessories Troubleshooting MaintenanceService Warranty PORTER-CABLE Limited ONE Year Warranty Canadian PORTER-CABLE Delta Service Centers Michigan