Porter-Cable 4212, 4210 instruction

Note: Rockler may not carry all products and/or sizes listed in this vendor's publication

SUPPLEMENTARY

INSTRUCTIONDOVETAIL JIG MANUAL

To learn more about Porter-Cable

visit our website at:

http://www.porter-cable.com

Copyright © 2005 Porter-Cable Corporation

MODELS 4210 & 4212

(39887)

IMPORTANT

Please make certain that the person who is to use this equipment carefully reads and understands these instructions before starting operations.

The Model and Serial No. plate is located on the main housing of the tool. Record these numbers in the spaces below and retain for future reference.

Model No. _____________________________________

Type __________________________________________

Serial No.______________________________________

RTD10000211AA Part No. A06477 - 02-23-05

Image 1

Porter-Cable 4212, 4210 instruction manual Supplementary Instructiondovetail JIG Manual

Contents

Supplementary Instructiondovetail JIG Manual Table of Contents Important Safety Instructions Safety Guidelines Definitions Replacement Parts Additional Safety RulesBackground Information Miscellaneous Techniques Operation Templates Mounted to Clamping Boards SetupTHROUGH-DOVETAILS with Clamping Boards Cutting the Tails Cutting the Pins Fitting the Joint THROUGH-DOVETAILS with Unlimited Board Width Set the router bit depth, using the pencil mark from Step Fitting the joint is identical to the previous section a Blind Dovetails with Tail Boards Thicker than 7/8 HALF-BLIND Dovetails with Clamping Boards Wood Grain Cutting the Joint Using a Router Table THROUGH-DOVETAIL Bits Alternate Router BitsTHROUGH-DOVETAIL BIT Combinations Readily Available HALF-BLIND Dovetail BIT Readily Available BOX Joint Bits Readily Available BOX Joint BitsDovetail Dado Bits HALF-BLIND Dovetails with Tail Boards Thicker than 7/8 Mitered THROUGH-DOVETAIL Mitering the Pins Mitering the Tails THROUGH-DOVETAIL, SKIPPED-PIN Method HALF-BLIND DOVETAIL, Skipped PIN Method Cutting the Pins SAW Kerf Allowance Method Cutting the Tails END-TO-END Joints Multiple Spacer MethodFitting and Cutting the Joint BOX END-TO-END Joints Dovetail END-TO-END Joints Drawers with Dovetail Dados Hinges with a Drilled Hole Wooden Hinges Hinges with ROUTER-MADE Grooves Hinges with ROUTER-MADE Grooves Angled Joints Setup with the Template Mounted to the Base of the JIGObtuse Angled Joints Cutting the Tails Setup with the Template Mounted to a Clamping Board Cutting the Pins Acute Angled Joints SLANTED-SIDE Joints COMPOUND-ANGLE Joints Setup Blade Tilt Angle Make Angled CUT Inlayed Through Dovetail Inlayed JointsMake the First Joint CUT OFF the Inlay Board Inlayed HALF-BLIND DovetailMake the Second Joint 100 13/128 050 042 028 014 Inlayed BOX Joint Through Dovetail Router BIT Combinations Tables of Commonly Available Router BIT SizesHALF-BLIND Dovetail Bits BOX Joint BIT Combinations Service Troubleshooting MaintenanceAccessories PORTER-CABLE Limited ONE Year Warranty Warranty Michigan Canadian PORTER-CABLE Delta Service Centers