C O M M E R C I A L P R O D U C T S D I V I S I O N
Setting Up the C846
You do not need any special knowledge or experience to set up the cycle. However, because of its size and weight, you will need to obtain assistance.
HARDWARE KIT
After unpacking the cycle, open the hardware kit and make sure that you have the following items shown in Diagram 1.
❑(A) rubber bib
❑(B) two hex head cap screws
❑(C) two large washers
❑(D) four 1C\v - inch buttonhead screws (The four buttonhead screws are used in the assembly of the Recumbent C846 Cycle. If you purchased the Upright C846, you can discard the buttonhead screws.)
❑(E) C\zn - inch hex key
Diagram 1 Hardware kit (not shown to scale).
B
D E
A
C
INSTALLATION REQUIREMENTS
Follow these installation requirements when installing the C846. If you do not install the C846 according to the following guidelines, you could void the Precor Limited Warranty.
•Set up the C846 on a solid, flat surface. Assemble the C846 close to where you’ll use it. Make sure that the flat surface under the unit is smooth and level. A level unit is required for the user’s safety and for proper operation.
•Provide ample space around the unit. Open space around the unit makes for a safer mount and dismount.
•Fill out and mail the limited warranty card.The serial number is located on a label near the optional battery recharger receptacle. Write the serial number onto the Precor Limited Warranty card found on the back cover of this manual. Refer to Obtaining Service on page 7 and write the number there as well.
page 9
