Diagram 7

Attach the

 

console to the left

 

upright support.

Buttonhead screws

10.Secure the display console to the left upright support. Diagram 7. Align the mounting holes on the console to those on the left upright support. Insert 2 screws (A) and washers (B). Do not securely tighten the screws until after the handrails have been attached.

Important: With the handrails attached, the width of the treadmill is 36.75” (93 cm). It will not fit through a standard 36” doorway.

Diagram 8

Handrail alignment and installation.

1

2

 

Console

 

extension

 

3

11.Attach the handrails. Diagrams 8 and 9. For ease of assembly, place the side rails or rear feet on blocks. Obtain assistance to lift the treadmill. Do not place blocks beneath the running bed.

To attach the handrails, perform the following steps on one side at a time:

a.Alignment pins on the top of the handrails necessitate sliding the handrails into the console assembly at an approximate 45o angle. Position the handrail as shown in Diagram 8 and slide it onto the console extension. When the alignment pins are fully engaged, carefully lower the handrail toward the base. Place as washer (D) on each of 2 screws (C). Insert the screws and finger-tighten.

page 14

Page 14
Image 14
Precor M9.55 owner manual Console