5 | Programming the M9.55 Treadmill |
Several aspects of the M9.55 treadmill can be programmed. This section provides | |
instructions on how to: |
• select U.S. standard or Metric display
• enable or disable password protection
• create a user name
• view the odometer, hours of use, software version, and error log
Selecting a U.S. Standard or Metric Display
The M9.55 treadmill can display speed in either miles per hour (mph) or kilometers per hour (kph) and distance in miles or kilometers. When the M9.55 is shipped from the factory, it is set to display to U.S. Standard units of measure (mph and miles). You can easily change this setting by taking the following steps:
1.Check that the treadmill is ON. If necessary, turn ON the treadmill using the power switch located at the front of the hood.
2.At the Precor banner, use the red Stop button and number keys. Press the following keys in sequence:
Red Stop button, 5, 6, 7, 1
The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
Important: If the second key press (the number 5 key) is not pressed within ½ second after pressing the Stop button, the display returns to the Precor banner. You will need to begin again.
3.The prompt, “Select Units” appears on the display. Then, the current unit of measure appears. Any ▼ or ▲ key lets you alternate between the prompts.
4.Once your selection is displayed, three options exist. You can,
a.press Enter to accept the unit of measure being displayed and continue with programming the treadmill. The changes have been retained in the treadmill’s memory. The M9.55 treadmill will retain your selection even when it is turned OFF and unplugged.
b.press Stop which keeps the current unit of measure unchanged and lets you continue with programming the treadmill.
Note: The “current unit of measure” is not necessarily the one being displayed. It refers to the unit of measure that was in existence prior to entering the “Select Units” program.
c.press Reset which keeps the “current unit of measure” unchanged, ends the programming mode, and returns to the Precor banner.
Important: If you choose to change the units of measure, then any existing custom course records are deleted. Interval courses are also affected. Any rest and work interval segments stored in memory are reset to 1 mph or 1.5 kph (respective of which unit of measure you choose).
page 32
