CAUTION: After entering the password, the belt starts moving after the short warning message, “ Belt Starting 3, 2, 1,...” appears on the display.
CAUTION: If you hear any chafing or the running belt appears to be getting damaged, stop the running belt immedi- ately by pressing the red Stop key. Contact Precor Customer Support.
3.Turn ON the treadmill.
4.Stand to the side of the treadmill and press Quick Start, enter the password (if necessary) and then increase the running belt speed to 3 mph (5 kph) by pressing Speed ▲.
Important: The running belt begins moving automatically after you perform step 4.
5.Observe the running belt for a couple of minutes. The belt should be centered on the running bed. A few inches from either side of the side rail platform.
6.If the belt needs additional alignment, repeat steps 1 through 4 of this procedure until the belt is properly aligned.
7.Press Stop (the running belt slows and stops moving). To return to the Precor banner, press Reset.
Servicing the Treadmill
Do not attempt to service the treadmill yourself except for the maintenance tasks described in this manual. The unit does not contain any
Long Term Storage
When the treadmill is not in use for any length of time, turn it OFF. Ensure that the power cord is unplugged from the wall outlet and is positioned so that it will not become damaged or interfere with other equipment or people.
page 43
