TOC | INDEX |
D. SETUP THE KIOSK BIN
Kiosk Mode allows you to use both of Publisher's Bins as input, doubling your disc capacity from 50 discs to 100 discs. In this mode, the finished discs will be deposited out through the front "reject area" of the Publisher. In Kiosk mode all discs would be ejected in this manner. Rejects can be identified in the stack because they will not be printed in the same manner as successfully recorded discs. Refer to the Kiosk Kit installation instructions below.
•Attach the Output Bin Holder as shown, aligning
the Locating Tabs on the |
| |
Output Bin Holder with |
| |
the Slots located on the |
| |
underside of the Publisher | Slots | |
allowing the holder to |
| |
hang off the edge of the |
| |
table. Notice the slots do |
| |
allow for adjusting the |
| |
position of the output bin. |
| |
If your discs are not |
| |
falling into the bin, you |
| |
will be able to move the | Locating Tabs | |
bin slightly to align it. | ||
|
•Place the Output Bin on
the Output Bin Holder as shown.
To enable Kiosk Mode, Open PTPublisher - select Options from the Tools menu - find the Options tab - now check the Kiosk Mode box. On a Mac, Kiosk Mode can be enabled in the the Robot Options menu.
16Hardware and Software Setup
