To load your master disc onto a hard drive partition, please do the following:
1.Make sure the Master Reading Source is set to the Hard Drive.
2.
It is very important to make sure the Master Reading Source is set for the Hard Drive in order to avoid unnecessary error messages. To check the Master Reading Source, please do the following:
a.Use UP or DOWN arrow button to navigate to the following screen.
DUPLICATOR 1.00
8.Select Source
b.Press “>>” to enter Select Source Menu and you shall see the following:
Hard Drive Port 0 WDC WD400EB-75CPF0
Make sure it is located at “Hard Drive”. If not, then you need to press UP or DOWN navigation button to search for it.
c.Press “>>” to submit your selection. After your selection has been submitted, you will see the following:
DUPLICATOR 1.00
8.Select Source
- 31 -
