Setup Guide
I. Setup USB 2.0 / Firewire device(s)
(This only applies if you have USB 2.0 or Firewire connections installed)
•If there’s a switch next to the USB/Firewire Port:
1.Turn your duplicator off if it is running.
2.Turn your computer off if it is running.
3.Set the USB2.0/Firewire switch to “ON” at the back of your duplicator.
4.Using the standard USB 2.0/Firewire cable to connect your computer and your duplicator.
5.Turn on your duplicator.
6.Turn on your computer.
7.After that, your computer will recognize a number of external devices depend on the machine you purchased.
You need to reboot your duplicator every time you want to turn on/off the USB 2.0/Firewire Device(s).
•If there is NOT a switch next to the USB/Firewire Port:
1.Turn your duplicator on.
2.Go to “12. Setup”
3.Go to submenu “USB Connection” / “Firewire Connection”
4.Press UP or DOWN key to “ON”
5.Press (“>>”/Ent.) Key to submit your selection.
6.The duplicator will restart and the computer should detect an
external writer.
Every PC related product has compatibility issues. Even though the USB 2.0/ Firewire connection(s) have been thoroughly tested before the unit was shipped out of the factory, there’s still a slight chance that your PC/Mac computer is not compatible with the units USB 2.0/ Firewire connection. If that happens, please contact your PC/Mac manufacture for possible configuration changes to make it work or try it on another PC/Mac computer.
- 64 -
