Media Requirements
The printer requires continuous form media with 0.5 inch pitch tractor feed pin holes. The media capabilities and requirements are listed in the following table:
Dimension | Specification | |
|
| |
|
| |
Width | 4.0 to 10.0 inches edge to edge | |
| (3.5 to 9.5 inches pin to pin) | |
Length | 3.0 to 33.0 inches | |
| in 1/8 or 1/6 inch increments | |
|
|
Weight
Labels:
Face Stock
Carrier
Adhesive
Cut to Tie (page perf)
18 to 42 lb. bond
110 lb. tag stock
99 lb. card stock
40 to 60 lb. book stock
50 lb. book stock acrylic
≥2.9:1 (8 cuts/inch) bond (and microperf)
≥6.5:1 (4 cuts/inch) tag/card stock
≥6.5:1 (4 cuts/inch) label stock
Percent Recycled paper | 20% maximum | |
Moisture Content |
| |
5% + 1% | ||
Resistivity | 108 to 1012 ohms | |
note
Bond paper weight based on 17 X 22 inch base size. Tag stock based on 24 X 36 inch base size. Card stock based on 22 1/2 X 28 1/2 inch base size. Book carrier stock based on 25 X 38 inch base size.
Operator's Guide | 11 |