status and error messages
Fatal Error Messages
This section provides a description of error conditions that cause printing to stop. These errors are provided for information only. The corrective action in all cases is to first perform the reset function (described on page 8). If the printer reset does not solve the problem, cycle the printer power. If a reset or power cycle does not solve the problem, call your authorized service representative.
| Message | Problem |
|
|
|
|
|
|
15 | FUSER FAIL | A rotation error of the pressure roller cam has |
Call Service | occurred. There is an unfused image at fuser. | |
| FUSER FAIL | Pressure roller cam did not stop or is out of position |
16 | ||
Call Service | after stop attempt or the sensor is bad. | |
|
|
|
17 | FUSER FAIL | Pressure roller cam did not start or the sensor is bad. |
Call Service |
| |
|
|
|
18 | FUSER FAIL | The sensor that detects the position of the speed |
Call Service | control plate is defective. | |
|
|
|
23 | THRMISTR FAIL | Thermistor wire broken or thermistor is open. |
Call Service |
| |
|
|
|
24 | THRMISTR FAIL | Thermistor shorted or extraordinarily high temperature. |
Call Service |
| |
|
|
|
25 | ENCODER FAIL | Defective or dirty encoder needs to be replaced. |
Call Service |
| |
|
|
|
26 | HEATER FAIL | Fuser did not warm up within specified time. |
Call Service |
| |
27 | HEATER FAIL | Fuser temperature not maintained during printing. |
Call Service |
| |
|
|
|
28 | BEAM DET FAIL | Beam detect failure. Motor spinning but not generating |
Call Service | interrupts. | |
|
|
|
36 | Operator's Guide |