Proxima ASA Multimedia LCD Projectors manual Sync Keys

Chapter 3 • Using the Desktop Projector

Note: Press the MENU key twice in rapid succession to:

•Go directly to the Setup Menu, or

•Exit the Menu Window from the Levels Menu.

Hold down the MENU key for several seconds to calibrate Cyclops. For more information, refer to the Cyclops User’s Guide.

Note: You cannot use Cyclops and Proxima’s Presentation Control Software at the same time. To disable Cyclops and use the software, hold the MENU key on the Control Panel down when you turn the projector power on. This procedure will not work with the remote control. To re-enable Cyclops, turn the projector off and then turn it back on.

SYNC Keys

The SYNC keys compensate for fine variations in the timing of a computer's video signal. Sync is only used with computer video. Adjust this setting if you see uneven horizontal features, streaks or shimmering in a graphic image. Press the upper or lower SYNC key until the image stabilizes.

VIDEO Key

The VIDEO key is used to switch between computer video input, NTSC/PAL/SECAM video input, or S-VHS input. This key is only operational on Audio/video-enabled models.

Note: If you would like to add video to audio-enabled models, you can order the Video Adapter Kit (A195). See Appendix B for ordering information.

User’s Guide • 3–3