Quadra-Fire 7046-137C warranty Leveling Legs, Flue Adapter

2700-I ACC Wood Insert

R

B. Optional Elbow Flue Adapter Installation C. Securing Stove Pipe/Liner to Flue Collar

Optional use of a Simpson Duravent 15° Universal Elbow Part Number 4615 may be purchased directly through your local Simpson Durvent Pipe Distributor or from your local Quadra-Fire dealer, Part Number 15DEGADAPT.

Figure 40.1 shows a vertical installation and also how to create an optional 30° elbow installation.

The 15° elbow may be secured directly to the flue collar. Follow the pipe manufacturer’s instructions for using screws or rivets for attachment. Most pipe manufacturer’s 6 inch (152mm) diameter flue liners may be attached directly to the top of the 15° elbow.

1.There are 4 pre-drilled holes in the flue collar 90 degrees apart. Attach the flue collar to the stove pipe/liner. If the seal is questionable use stove mastic Figure 40.2.

2.Attach gasket to bottom side of flue collar with a thin coat of silicone.

A
Vertical	B	A

30o

30 degree B

	Gasket
Flue Collar	Stove Pipe/Liner
Figure 40.2

D.Leveling Legs

1.Remove the 2 screws already installed on each leg.

2.Move legs to the desired height.

3.Re-install the screws to secure in place.

Figure 40.1
Flue	A	B
Adapter
Vertical	13-9/16 in. (344mm)	20-15/16 in. (532mm)
30 Degree	14-5/8 in. (371mm)	20-11/16 in. (525mm)

Remove 2 screws from both sides. Adjust the legs up or down to level appliance.

Figure 40.3

Page 40 7046-137C December 15, 2009