Quadra-Fire 7046-137C warranty Blower Operating Instructions

R

2700-I ACC Wood Insert

M.Blower Control Box & Snap Disc Operating Instructions

1.The blower will turn on/off automatically when set to AUTO. Figure 15.1.

2.When set to MANUAL, the fan will turn on/off only when you turn it on or off. This setting over-rides the internal snap disc.

3.Adjust the speed of the fan by turning the HIGH/LOW knob to the desired setting.

MANUAL: Over-rides the internal Snap Disc

AUTO: Fan will turn ON/OFF automatically and is controlled by the internal Snap Disc

N. Blower Operating Instructions Figure 15.1

1.Initial (cold) startup: Open both controls fully by rais- ing the Burn Rate Air Control all the way up until it stops and PUSH the Start-up Air Control back until it stops. The blower tends to cool the appliance. Leave the blower off until the burn is well established, i.e., 30 minutes.

2. High Burn Setting: Both controls are open. Burn Rate Air Control is pulled up and the Start-up Air Control is fully pushed in. Blower may remain on.

3.Medium-High Burn Setting*: Burn Rate Air Control is closed then opened to 1 inch to fully open (pull up). Blower may remain on.

4.Medium-Low Burn Setting*: Burn Rate Air Control is closed then opened to 1/4 inch to 1/2 inch (pull up). Leave the blower off until the burn is well established, i.e., 30 minutes.

5.Low Burn Setting*: Burn Rate Air Control is closed (down position). Leave the blower off until the burn is well established, i.e., 30 minutes.

*NOTE: For burn settings 3 to 5 the Start-up Air Control needs to be pushed in (Open) then pulled forward to activate the Automatic Combustion Control (ACC).

NOTE: For maximum efficiency and lowest emissions, when operating the blower in either the automatic or manual setting for the low and medium low burn settings leave the blower off until the burn is well established, i.e., 30 minutes.

6.The blower is equipped with a rheostat (speed control). The highest blower speed is obtained by turning the rheostat on, then adjusting back towards “OFF” as far as possible without turning the blower off. For a low blower speed, turn the control knob clockwise as far as possible

NOTICE!

Do NOT operate a circulating fan within close proxim- ity, approximately 4 ft (1.2m), of appliance

•Can reverse air flow, blowing hot air into appliance cavity.

•Can damage appliance blower due to overheating.

December 15, 2009 7046-137C Page 15