2700-I ACC Wood Insert

R

L. Wood Fuel

WARNING

Fire Risk.

Do NOT burn garbage or flammable fluids such as gasoline, naptha or engine oil.

DO NOT USE CHEMICALS OR FLUIDS TO START A FIRE.

Do NOT burn treated wood or wood with salt (driftwood).

May generate carbon monooxide if burn material other than wood.

May result in illness or possible death.

Hardwood vs Softwood

Moisture

The majority of the problems appliance owners experience are caused by trying to burn wet, unseasoned wood.

Wet, unseasoned wood requires energy to evaporate the water instead of heating your home, and

Causes evaporating moisture which cools your chimney, accelerating formation of creosote.

WARNING

Fire Risk.

Do NOT burn wet or green wood.

Store wood in dry location.

Stack wood so both ends are exposed to air. Wet, unseasoned wood can cause accumulation of creosote.

Your appliance performance depends on the quality of the firewood you use.

Seasoned wood contains about 8,000 BTUs per pound .

Hard woods are more dense than soft woods.

Hard woods contain 60% more BTUs than soft woods.

Hard woods require more time to season, burn slower and are harder to ignite.

Soft woods require less time to dry, burn faster and are easier to ignite.

Start the fire with softwood to bring the appliance up to operating temperature and to establish draft.

Seasoned Wood

Cut logs to size

Split to 6 inches (152 mm) or less in diameter

Air dry to a moisture content of not more than 20%

-Soft wood - about nine months to dry

-Hard wood - about eighteen months to dry

Notice: Seasoning time may vary depending on drying conditions.

Add hardwood for slow, even heat and longer burn time.

Soft woods

Hard woods

Douglas Fir

Oak

Pine

Maple

Spruce

Apple

Cedar

Birch

Poplar

 

 

Aspen

 

 

Alder

 

 

 

 

 

 

Processed Solid Fuel Fire Logs

NOT permitted for use in this appliance

Storing Wood

Steps to ensure properly seasoned wood:

Stack wood to allow air to circulate freely around and through woodpile.

Elevate wood pile off ground to allow air circulation underneath.

Smaller pieces of wood dry faster. Any piece over 6 in. (152 mm) in diameter should be split.

Wood (whole or split) should be stacked so both ends of each piece are exposed to air. More drying occurs through the cut ends than the sides.

Store wood under cover to prevent water absorption from rain or snow. Avoid covering the sides and ends completely.

WARNING

Fire Risk

Do NOT store wood:

In front of the appliance.

In space required for loading or ash removal.

Page 14

7046-137C

December 15, 2009

Page 14
Image 14
Quadra-Fire 7046-137C warranty ACC Wood Insert Wood Fuel, Do not USE Chemicals or Fluids to Start a Fire