Quadra-Fire 7046-137C Listing and Code Approvals, Appliance Certification, Mobile Home Approved

2700-I ACC Wood Insert

R

1 Listing and Code Approvals

A. Appliance Certification

Model:	2700-I (ACC) Insert
Laboratory:	OMNI Test Laboratories, Inc.
Report No:	061-S-78-6.2, 061-S-52b-3
Type:	Solid Fuel Type, Listed Room Heater
Standard:	UL1482 and ULC S628-93 and
	(UM) 84-HUD, Mobile Home
	Approved.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the UL1482, (UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S628- 93 and CAN/CSA-B365 Installation Codes in Canada.

D. BTU & Efficiency Specifications

EPA Certified:	3.5 grams per hour
Efficiency:	up to 84.1%
BTU Output:	10,450 to 16,400
Heating Capacity:	up to 1800 sq ft depending
	on climate zone
Vent Size:	6 inches
Firebox Size:	1.75 cubic feet
Max Wood Length:	18 inches
Fuel:	Cord Wood
Shipping Weight:	240 lbs

The Quadra-Fire 2700-I Wood Insert (ACC) meets the U.S. Environmental Protection Agency’s 1990 particulate emis- sion standards.

B. Mobile Home Approved

•This appliance is approved for mobile home installations when not installed in a sleeping room and when an out- side combustion air inlet is provided.

•The structural integrity of the mobile home floor, ceiling, and walls must be maintained.

•The appliance must be properly grounded to the frame of the mobile home with #8 copper ground wire, and use only listed double-wall connector pipe.

•Outside Air Kit, part OAK-ACC must be installed in a mo- bile home installation.

C. Glass Specifications

This stove is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance.

•Modification of the appliance.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

•Operating appliance without fully assembling all components.

•Operating appliance without legs attached (if supplied with unit).

•Do NOT Overfire - If appliance or chimney connector glows, you are overfiring.

Any such action that may cause a fire hazard.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualified installer, service agency or your dealer.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

Quadra-Fire is a registered trademark of Hearth & Home Technologies.

Page 7046-137C December 15, 2009