R
2700-I ACC Wood Insert
H. Blower Cord Installation on Left Side
The blower cord is shipped to be installed on the right side of the appliance. You may relocate the cord so it is on the left side. You remove the blower control plate and wire har- ness as one assembly and reconnect on the left side. The cover plate on the left side is
Instructions
1.Remove the blower assembly from the appliance. Using a 5/32 Allen wrench remove the 4 mounting bolts and slide the assembly towards you.
2.Using needle nose pliers bend the tabs up that holds the wire harness in place and remove the wires. There are 2 tabs, one at the top of the assembly and one at the bottom.
3.Disconnect the power leads to the blower.
4.Remove the snap disc mounting plate by removing the 2 sheet metal screws with a Phillips head screw driver.
5.Disconnect the spade terminals to the snap disc.
6.Remove the blower control plate using a flat head screw driver to remove the 2 screws, 1 on the top and 1 on the bottom. Remove the blower control plate and wire har- ness at the same time.
7.On the left end of the blower housing, remove the cover plate and
8.Install the blower control plate on the left end and secure the wire harness underneath the tabs on the left side and bend the tabs back into position.
9.
10.
Snap Disc Location |
Remove Bolts and Slide |
Blower Assembly Out |
Figure 43.1
|
|
|
|
|
|
|
|
|
| Snap Disc |
| ||
|
| Blower | ||||
|
|
| Mounting Plate |
| ||
|
|
|
| Control | ||
Cover |
|
|
|
|
| |
|
|
|
|
| Plate | |
Plate |
|
|
|
|
| |
| Snap Disc |
|
|
| ||
|
|
|
| |||
|
|
|
|
|
|
|
Wire Harness Tabs Locations
Left Side | Right Side |
|
Figure 43.2
Bend Wire Harness Tab
Figure 43.3
Snap Disc
Mounting Plate
Disconnect Spade
Terminals from Snap Disc
Figure 43.4
Figure 43.5 - Installed on Left Side
December 15, 2009 | Page 43 |
