Chapter 5 ATAPI Interface
Page 78 Seagate Travan 40 Product Manual
Sense Key
ASC ASCQ
Meaning
04 44 00 Hardware error occurred
04 44 81 Fan error
04 47 00 SCSI parity error non-command state
04 47 00 SCSI parity error in command state
05 00 00 Attempted to erase tape when not at BOT
05 20 00 Invalid CDB opcode
05 21 00 Invalid LBA
05 22 00 Invalid function requested
05 24 00 Invalid data byte in CDB
05 25 00 Invalid LUN
05 26 00 Invalid parameter in data
05 2C 00 Log select failed
05 3D 00 SCSI bad id
05 3D 00 SCSI parity error in identify message
05 49 00 SCSI LUN is non-zero (in msg)
05 50 00 Attempted to write when not at either BOT or EOD
05 53 02 Command not allowed because of previous Prevent/Allow
CDB command
06 28 00 Media just came ready, normal status after cartridge
insertion
06 29 00 Drive was just initialized, normal status after power-on
06 2A 00 Mode select parameters changed
06 2A 02 Log select parameters changed
06 5D 00 Tape alert- unit attention
06 5D FF Tape alert- bad mode
07 27 00 Attempted to write on a write-protected cartridge
08 00 05 Read or located into EOD: blank check
0B 00 00 Host aborted the command
0B 00 00 Command was aborted
0B 00 00 ATA 'nop' command
0B 3A 00 Cartridge was removed before a medium operation was
completed
0B 48 00 SCSI error - extended message
0B 49 00 SCSI error - bad message (not in command state)
0B 49 00 Fatal drive firmware error occurred
0B 49 00 SCSI error (received bad message while in command state
0B 4E 00 Command was aborted because of attempted command
overlap condition