General, Unpacking | RAD Data comm ARC-101 specification

Chapter 2

Installation

This chapter contains mechanical and electrical installation procedures for connecting the ARC-101 to the main power supply, as well as cabling the ATM links and monitor (control) port.

2.1 General

The ARC-101 is delivered completely assembled for bench-top installation. The ARC-101 may be optionally installed in a 19" rack (refer to Section 2.4).

2.2Unpacking

∙Inspect the equipment container before unpacking. Note and report evidence of damage immediately.

∙Place the container on a clean flat surface. Cut all straps and open, or remove top.

∙Remove the unit carefully and place it securely on a clean surface.

∙Remove all packing material and inspect the unit for damage. Report any damage immediately.

Site Requirements

2-1

Image 17

RAD Data comm ARC-101 operation manual General, Unpacking

Contents

RAD data communications Headquarters US East US West ARC-101Page Warranty Safety Status Ports Safety Warnings Regulatory Information Supplementary Information Safety Contents Operation List of Figures List of Tables General Description Chapter Introduction Interfaces Supported ARC-101 Features Traffic Management Loopback Mode Specifications RM-2 Ordering ARC-101/#RM-1 Introduction Specifications Unpacking General Rack Mounting Instructions Site Requirements Cable Connections InstallationTwo Units ATM Connection Control Port Pinout Changing Control Port Mode Grounding AC Power Connection ARC-101 Modules Module CharacteristicsSC13M/155 Module ST13S/155 Module CX/BNC/155 Module ST13L/155 Module 12 UTP/155 Module Front Panel UTP/155 Module T3 Module E3 Module Modules E1 and E1/LTU Inserting Modules Removing Modules Inserting Removing Modules For E1 and E1/LTU Jumper Settings 17 T3 Jumper Locations Jumper Settings for T3 Installation Name Description Chapter Operation Operating Procedure ARC-101 Block Diagram Operation ARC Menu Accessing, Using and Exiting Monitor ModeIntroduction Screen Explanations Configuration WindowGeneral Information Window General Information System ConfigurationParameters ALL Changes will be SAVED. are YOU SURE? Y/N Left Module Right/Left Module Configuration Ascii Terminal Configuration Ascii Terminal Configuration Performance Monitoring Window Diagnostics WindowDiagnostics Link Status SLM SONET/SDH Link Status Window LOS LOC OOF AIS RDI BIP Febe T3 Link Status Window Errors/Alarms displayed in Plcp Mode ATM Status ATM TrafficE3 Link Status Window E1 Link Status Window Counter precision is 1/10,000 Software Management Performance Monitoring Window