RAD Data comm ASMi-31 operation manual Package Contents, Installation and Setup

Chapter 2. Installation and Setup ASMi-31Installation and Operation Manual

2.2 Package Contents

•

•

•

•

One ASMi-31 unit (protected by adequate cushioning)

AC power cord or DC power supply connector kit

ASMi-31 Installation and Operation Manual

Interface adapter cable(s) (see Table 2-2) - Optional.

2.3 Installation and Setup

ASMi-31 is a standalone device intended for tabletop or bench installation.

It is delivered completely assembled. No provisions are made for bolting

ASMi-31 to the tabletop. For installation of the unit in a 19" rack, refer to

Appendix F.

➤To complete the installation of ASMi 31:

1.Determine the required configuration of the modem according to your application, and set the internal jumpers and switches accordingly (see and .

2.Connect the line (see Connecting the Line below).

3.Connect the DTE interface (see Connecting the DTE below).

4.Connect power to the unit (see Connecting the Power below).

Setting the	This section provides information on the functions of the internal jumpers
Internal Jumpers	and switches, to help you in the selection of the correct settings for
	particular application, and gives you step-by-step instructions for
	performing the internal settings. The default settings are also listed.
	1.	Open the ASMi-31 case.
	2.	Set the ASMi-31 internal jumpers and switches, referring to Figure 2-1
		and Table 2-1.
	3.	Reinstall the ASMi-31 cover.

2-2 Installation and Setup

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com