Chapter 2. Installation and Setup ASMi-31
Installation and Operation Manual
2-8 Installation and Setup 16-05-01 13:37
Table 2-2 DTE Interfaces and Matching Adapter Cables (Cont.)
DTE Interface Connector Description RAD Cable
RS-530/RS-449 25-pin, D-type connector. For a description of the
cabling connection between the RS-530 interface and
the RS-449/RS-442 (V.36) 37-pin, D-type connector,
see Appendix E. The cable is provided with the
product.
CBL-HBT/RS-530
G.703 Codirectional 64 kbps interface. For a description of
the G.703, see Appendix B.
Ethernet Interface RJ-45 or BNC connector. For a description of the
Ethernet interface, see Appendix A.
Connecting the Power
The AC power is supplied to the ASMi-31 unit through the 1.5m (5 ft)
standard power cable terminated in a standard 3-prong plug (see Figure 2-
2). The cable is provided with the unit.
The rated fuse for the unit is 250V / 0.1A slow-blow for 230V, or
250V / 0.2A slow-blow for 115V.
Warning
The unit has no power switch. Operation starts when the power is
applied to the rear-panel POWER connector.
Before switching on this instrument, the protective earth terminals of
this instrument must be connected to the protective ground conductor
of the power cord. The power plug shall only be inserted in a power
outlet provided with a protective earth contact. The protective action
must not be negated by use of an extension cord (power cable) without
a protective conductor (grounding).
Make sure that only fuses with the required rated current, as marked on
the ASMi-31 rear panel, are used for replacement. The use of repaired
fuses and the short-circuiting of the fuse holders is forbidden.
Whenever it is likely that the protection offered by fuses has been
impaired, the instrument must be made inoperative and be secured
against any unintended operation.
➤
➤ ➤
➤ To connect AC power to ASMi-31:
1. Connect the power cable to the connector on the ASMi-31 rear panel.
2. Connect the power cable to the mains outlet.
The unit will be turned on automatically upon connection to the
mains.
➤
➤ ➤
➤ To connect DC power to ASMi-31:
• Refer to DC Power Connection Supplement.
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com