RAD Data comm MBE10-1D Type 24/RS-232, Green On when the unit is powered-up, Reset Front panel

MBE Family Installation and Operation Manual			Chapter 1 Introduction
Control	Type		V.24/RS-232
Interface
	Connector		RJ-45
	Data Rate		2.4 to 19.2 kbps, 8 bits, No Parity,
			Automatic rate detection
LED	POWER	(green)	On when the unit is powered-up
Indicators
	READY	(green)	On when packets can be transferred
	MAIN	(green)	On when the unit is configured as local (applicable to
			Bridge mode only)
	REMOTE	(green)	On when the unit is configured as remote (applicable to
			Bridge mode only)
	LAN TX	(yellow)	On when a packet is being transmitted to the LAN
	LAN RX	(yellow)	On when a packet is being received from the LAN
	LAN ERR	(red)	On when LAN interface indicates an error
	LINK TX*	(yellow)	On when a packet is transmitted to link
			Blinks (every 15 seconds) when a synchronous link is
			connected and the link is open
	LINK RX*	(yellow)	On when a packet is being received from the link
			Blinks (every 15 seconds) when a synchronous link is
			connected and the link is open
	LINK ERR* (red)		On when the serial link interface indicates an error
			Blinks when the serial link interface indicates an error
	Note: *Refers to both Link 1 and Link 2 for dual port models
Panel	Reset		Front panel
Controls
	Power ON/OFF		Rear panel
Power Supply	Voltage		100–240 VAC (±10%)
	Frequency		50/60 Hz
	Power		10 VA Max

Technical Specifications 1-11

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com