Chapter 2 Installation MBE Family Installation and Operation Manual
2-8 Installation and Setup
POWER
OI AUI
TO V.35 LINE
100-230 VAC
Figure 2-5. MBE Rear Panel, V.35 Connector
POWER
POWER
O
O
I
I
TO RS-232/V.24
LINK 2 RS-232/V.24
LINK 1 RS-232/V.24
AUI
AUI
100-230 VAC
100-230 VAC
Figure 2-6. MBE Rear Panel, V.24 Connector
Connecting the Line A connector is provided to connect each interface to the communication link.
To connect the line:
• See Appendix A for LINK connector pin assignments. Note that the X.21 and
V.36 connections are provided by adapter cables to the RS-530 (25-pin
connector) on the MBE rear panel.
Interface cards are interchangeable. Consult your RAD dealer for details.
Connecting the LAN To connect to the LAN:
• Use a standard AUI (15-pin, D-type), 10Base2 (BNC) or 10BaseT (RJ-45)
connector, provided by RAD.
To ensure compliance with electromagnetic compatibility (EMC) requirements, it is
recommended that you only use shielded data cables with this product. Make sure
that the shield is connected to the metallic hood of the cable connector.
For units with V.35 ports, in order to protect against electrostatic discharge (ESD)
into the port, use a connector with an overlapping hood that completely covers
the pin connection.
Caution
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com