For EDACS and Motorola (above 406 MHz range), the scanner monitors the control channel between each transmission to identify talk groups. For some Motorola (under 512 MHz range) and LTR systems, the scanner uses the subaudible data sent with each transmission to identify talk groups.
Trunking Delay
You can set a Talk Group ID delay separately from the channel delay. When active, the scanner checks the Talk Group ID for the delay time when a transmission ends.
To set a Talk Group ID delay:
1.Press FUNC then ./DELAY while you are programming the Trunk Group ID. “ENTER key saves. 2.0 seconds” appears.
2.Use or to set ID Delay: None, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, or 4.0 seconds.
3.Press ENT.
Locking Out Talk Group IDs
You can only lock out Talk Group IDs when the scanner is in the Closed mode.
To lock out Talk Group IDs:
1.Press PGM then TRUNK.
2.Press FUNC, or to move to the desired bank.
3.Press or to select the ID.
4.Press L/OUT to lock out the ID. “lo” changes to “LO.”
5.To remove the lockout from a trunking ID,
T
1
2
3
4
T
T
1
2
T
1
2
3
42
