1.Remove jacket top panel.
2.Remove and discard inner stack adapter panel.
3. | Install jacket top panel. | JACKET TOP |
4. | Insert tabs of outdoor top into keyholes located on |
|
| jacket top panel (4 places). See Detail A. |
|
5. | Snap tabs on outdoor top into the locked position |
|
| of the keyhole so the top will not pull out. See | FASTENING |
| Detail B. | SCREW |
Detail A | Detail B |
Outdoor Top
(Shipped Loose with Heater)
Fig. 6: Installing Outdoor
400
Models 514-824
1.Lower outdoor top onto unit. Position top so it is centered on unit from side to side and front to rear.
Fig. 8: Installing Outdoor Top
Models
Boilers are shipped with outdoor vent terminal factory installed.
Indoor Installations
Model 133
1.
2.Turn heater manual switch located in upper control panel to the "OFF" position.
3.
4.Mount drafthood on boiler and attach with the sheet metal screws provided. Drafthood should be positioned with the vent sensor located on the front left side (see next page).
5.Remove plastic plug from left side of boiler jacket and install the plastic grommet provided.
6.Route flue sensor wire harness through the grom- met installed in Step 5.
7.Remove door and locate wire from
8.Disconnect male/female connector and attach to the 2 wires from drafthood vent sensor harness.
Fig. 7: Installing Outdoor
2.Tighten the (4) screws (as indicated in Fig. 8) until they come in contact with the unit jacket top, then evenly tighten all (4) screws to secure to unit.
10