SETUP AND CONNECTIONS

STEP 1: UNPACK THE SYSTEM

Make sure to locate the remote control and the other cables that are included with your HD receiver.

STEP 2: CONNECT YOUR HD RECEIVER TO

OTHER COMPONENTS

During the satellite dish antenna installation, your HD receiver may have been connected with just a coaxial cable for the system test. Depending on the components you have, another connection may provide better picture and audio quality. The following sections provide cable and connection information to help you decide what connection is best for you.

THINGS TO KNOW BEFORE CONNECTING COMPONENTS

Protect Your Components from Power Surges

Connect all components before plugging any power cords into the wall outlet.

Always turn off the TV and other components before you connect or disconnect any cables.

Position Cables Correctly to Avoid Audio Hum or Interference

Insert all cable plugs firmly into their jacks.

Place the Audio/Video cables to the sides of the TV’s back panel instead of straight down the middle after you connect your components.

Try not to coil any twin-lead cables; keep them away from the Audio/Video cables as much as possible.

Make sure all antennas and cables are properly grounded. Refer to the safety sheet packed with your unit.

Protect Your Components from Overheating

Do not block ventilation holes in any of the components. Arrange the components so that air can circulate freely.

Do not stack components.

Allow adequate ventilation when placing your components in a stand.

Place an amplifier on the top shelf of the stand so that heated air rising from it will not flow around other components.

VCR1 ONOFF TV

DVD

VCR2

AUX HD RCVR

MUTE

 

WHO

 

CH +

VOL

 

VOL

 

 

CH

FETCH

 

GO BACK

GUIDE

 

INFO

OK

MENUCLEAR

1 2 3

4 5 6

7 8 9

INPUT

 

ANTENNA

 

0

 

REVERSE

PLAY

FORWARD

RECORD

STOP

PAUSE

Remote Control

6

Page 8
Image 8
RCA manual Unpack the System, Connect Your HD Receiver to Other Components, Things to Know Before Connecting Components