INSTALLATION
250
253
254
6)Place the bottom left front edge of Log 251 against the left edge of the burner tray and
rest the log on the cutout on Log 253.
8) Pull off ember size pieces of rockwool and gently place them on the front of the burner tray in the places shown in the photo below. Do not compress the rockwool, leave it loose.
Diagram 1
250
251
253 | 254 |
Cutout
7)Position Log 252 across the cutouts in Logs 254 and 253. The notch in the bottom right end fi tting against the 5th grate tab.
252
253 | 254 |
|
5th Grate Tab
|
| 250 | |
251 |
| 252 | |
253 | 254 | ||
|
Place rockwool in these 2 locations
on the burner tray.
9)Test fi re to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner to the other). If there is any fl ame hesitation, check that area for any blockage of the burner ports.
10)Install fl ush glass and bay glass (if used) as per instructions in this manual.
STANDARD FLUSH
DOOR
The standard flush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1. Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. See Diagram 2.
Diagram 2
Use the hook to pull the spring out until you can put the hook into the slot on the bottom door bracket. Repeat for 2nd spring. See diagram 3.
Diagram 3
To remove the fl ush door, reverse the above steps.
OPTIONAL FLUSH
TRIM
Attach the round magnets to the back of the top trim piece and to the bottom trim piece, then attach trim to the top and bottom of Flush door.
Regency® | 31 |