INSTALLATION
VENTING
Regency® Direct Vent System (Flex) Horizontal Terminations Only
These venting systems, in combination with the P42 Direct Vent Gas | 1) | |
Fireplace, have been tested and listed as a direct vent heater system | 2) | 4" dia. fl exible liner (4 ft. length) |
by Warnock Hersey. The location of the termination cap must conform to | 3) | spring spacers (4) |
the requirements in the Vent Terminal Locations diagram in the "Exterior | 4) | thimble (2) |
Vent Termination Locations" section. | 5) | AstroCap termination cap (1) |
| 6) | screws (12) |
Regency® Direct Vent (Flex) System Termination Kit (Part # | 7) | tube of Mill Pac (1) |
includes all the parts needed to install the P42 with a maximum | 8) | plated screws (8) |
run of 4 feet. | 9) | screws #8 x 1/2" Drill Point, stainless steel (4) |
Wall Thimble (2 pc)
4" (102mm) | AstroCap | |
dia. flue pipe | Termination Cap | |
| Part | |
| ||
(173mm) dia. | spring | |
Flue pipe | ||
spacer | ||
|
If longer runs are needed, the Regency® Direct Vent system (Flex)
#
1)
2)4" dia. fl exible liner (10 ft. length)
3)spring spacers (7)
4)thimble (2)
5)AstroCap termination cap (1)
6)screws (12)
7)tube of Mill Pac (1)
8)plated screws (8)
9)screws #8 x 1/2" Drill Point, stainless steel (4)
Note:
a)Liner sections should be continuous without any joints or seams.
b)Only Flex pipe purchased from Regency® may be used for Flex Installations.
Regency® | 11 |