Regency P42-NG4, P42-LP4 installation manual Clearancesmantels, Mantel LEG Clearances

INSTALLATION

CLEARANCESMANTELS

The clearances listed below are Minimum distances unless otherwise stated:

A major cause of chimney related fires is failure to maintain required clearances (air space) to combustible materials. It is of the greatest importance that this fireplace and vent system be installed only in accordance with these instructions.

Clearance to Combustibles from:

Back 0" (0mm)

Side 0" (0mm)

Floor 0" (0mm)

Minimum Clearance from Louver to:

Mantel	min. 7"	(177mm)
Ceiling	36"	(914mm) from top
		of louvers
Side Wall	6"	(152mm)
Vent	1-1/2"	(38mm) Flex
	1-1/4"	(32mm) Rigid Pipe
Alcove Clearances:
Max. Depth	36"	(914mm)
Min. Width	52"	(1321mm)
Min. Height	90"	(2286mm)

WARNING

Fire hazard is an extreme risk

if these clearances are

not adhered to.

The HeatWave Duct Kit

and the Heat Release Kit have different clearance and framing

Heat Release Kit requirements, check the HeatWaveand Heat

Release manual for details.

Because of the extreme heat this fireplace emits, the mantel clearances are critical. Combustible mantel clearances from louver are shown in the diagram below.

Note: A non-combustible mantel may be installed at a lower height if the framing is made of metal studs covered with a non-combustible board.

This drawing is to scale at 1:6 (one inch = 6 inches)

Mantel can be installed anywhere in shaded area using the above scale for units with the Flush Front and with the optional Bay Front.

Note: Ensure the paint that is used on the mantel and the facing is "heat resistant" or the paint may discolour.

MANTEL LEG CLEARANCES

Combustible mantel leg clearances as per diagram below:

Maximum

1-1/2" projection at 2" minimum clearance.

8 Regency® P42-4 Zero Clearance Direct Vent Gas Fireplace